42. The Roof Gusset is positioned on center rafter. When correct, slide gusset up, use level to
square gusset and attach to rafter with 4 - 1 1/4” screws. Pilot hole Gusset to prevent splitting.
41. Secure Rafters to Top Wall Framing with one 3” screw per rafter. Screw through Wall Frame at
an angle. Have two helpers push the Front and Rear Walls at the top from the outside of shed until
inside to inside measurement between the Top Plates is 70”.
43. Starting in front corner, locate 5/8” x 78” x 32 1/4” Plywood Roof Section and place on top of
Roof Rafters. Position so Plywood overhangs outside Rafter by 4”. At bottom of Rafter, Roof Panel
should be flush with Rafter end.
Flush with end of
Rafter. Evenly
positioned on
Interior Rafter
4” overhang
past Rafter.
4“
1-888-658-1658 www.outdoorlivingtoday.com sales@outdoorlivingtoday.com
Page 19
70”
Comments to this Manuals